Preparing milk froth and warm milk, Dispensing hot water – Bosch TES803F9DE VeroSelection exclusiv Kaffeevollautomat Front Edelstahl Gehäuse hochglanz anthrazit User Manual
Page 43

39
TES803F.. | 04/2013
en
Preparing milk froth
and warm milk
¡
Risk of burns!
The milk frother
10 gets very hot. After use,
allow to cool down first before touching.
The appliance must be ready for use.
● Place the suction pipe
10d of the milk
frother
10 deep in the milk container 26.
● Place the pre-warmed cup or glass under
the outlet of the milk frother
10.
● Select the required setting
Milk froth
È
or
Warm milk
É
by turning the rotary
knob
6.
● Press the
start button 8.
Milk froth or warm milk flows from the outlet
of the milk frother
10.
Press the
start button 8 again to cut the
process short.
Info: When preparing warm milk, you may
hear a whistling sound. This is caused by
the milk frother
10 for technical reasons.
Tip: For optimal milk froth quality, use cold
milk with a fat content of at least 1.5 % if
possible.
Important: Dried milk residue is difficult
to remove, so the milk frother
10 must be
cleaned with lukewarm water immediately
after use (see “Cleaning the milk system”).
Dispensing hot water
¡
Risk of burns!
The milk frother
10 gets very hot. After use,
allow to cool down first before touching.
The appliance must be ready for use.
● Place the pre-warmed cup or glass under
the outlet of the milk frother
10.
● Select the required setting for
Hot
water
Ê
by turning the rotary knob
6.
● Press the
start button 8.
Please remove suction hose
start
● Remove the milk suction hose
10c and
press the
start button 8.
Hot water runs out of the milk frother
outlet
10.
Press the
start button 8 again to cut the
process short.
Note: It is possible to set the temperature of
the hot water (see “Menu settings”).
TES803F_MK.indb 39
08.05.2013 12:21:12