Bosch TASSIMO Multi-Getränke-Automat T55 TAS5542 opal black schwarz - Manual (Page 38)

36
Robert Bosch Hausgeräte GmbH
en
Problem Possible!cause Solution
Appliance not working;
no symbols light up.
There is no power supply. Check that the appliance is prop­
erly plugged into the power supply.
Machine brews but no
drink dispensed.
The water tank is not
correctly positioned.
Make sure that the water tank is
positioned correctly.
The water tank was
removed during the brew­
ing process or there is air
in the system.
Start a cleaning cycle with the
Service T DISC.
The loat in the water
tank is stuck.
Clean the water tank and ensure
the loat can move.
Drink size smaller than
usual.
Not enough water in the
water tank.
Fill the water tank after the drink
has inished dispensing and press
the start / stop button to inish the
drink.
The appliance needs
descaling.
Descale the appliance (for details
see “Descaling”).
More steam than usual. The appliance needs
descaling.
Descale the appliance (for details
see “Descaling”).
The appliance does not
recognise the inserted
T DISC and remains in
stand­by mode or the
Status LED F lights up
red.
No T DISC inserted. Check if T DISC has been inserted.
The barcode could not be
detected.
Clean the T DISC barcode reading
window and try again or smooth
the barcode on the T DISC out with
your thumb.
Use another T DISC.
If problems persist contact the
TASSIMO careline
08 00 032 88 33 (UK only)
The brewing system is
not properly closed.
Clean the brewing system thor­
oughly, especially in the area of the
clamp.
The quality of the foam /
crema has deteriorated.
The drink outlet is
clogged or dirty.
Remove the drink outlet from the
brewing unit and detach the pierc­
ing unit. After cleaning everything
thoroughly, reassemble the parts
and replace them in the brewing
unit.
Clean the brewing unit with the
Service T DISC.
The appliance needs
descaling.
Descale the appliance (for details
see “Descaling”).
TAS55.indb 36 26.08.2011 10:38:20