AEG 72620 - Manual (Page 29)

Operating Instructions
29
Washing machine
vibrates during opera-
tion or is unstable.
The machine is not level.
Adjust the feet according to
the installation and connec-
tion instruction.
There is only very little wash-
ing in the machine (e.g. only
a bath robe).
Does not impair function.
Water could not be com-
pletely pumped out prior to
spinning because
the drain hose is kinked or
the drain pump is blocked. Check the drain hose and if
necessary remove any kink or
clean the drain pump and
remove any foreign bodies
from the pump housing.
Excessive foaming dur-
ing the main wash Probably too much detergent
was used.
It may be necessary to
reduce the amount of deter-
gent used. Follow the deter-
gent manufacturer’s
recommendations.
Water runs out from
under the washing
machine.
Threaded fitting on the
water inlet hose is leaking. Tighten the inlet hose con-
nections.
The inlet hose has a leak.
Check the inlet hose and if
necessary replace it.
The drain pump cover is not
tight. Tighten cover by turning
clockwise.
Washing is caught in the
door.
Stop the program, remove
the washing caught in the
door, start a new program.
Fabric softener is not
added, compartment
À for fabric softener
is filled with water.
Suction cap in the fabric sof-
tener compartment is not
correctly fitted or is blocked. Clean detergent dispenser
drawer, place suction cap
firmly in position.
Washing is creased.
Too much washing was
placed in the appliance. Put less washing in the
appliance.
Malfunction Possible Cause Remedy