Bosch TCC78K751 Edelstahl Kaffeevollautomat - Manual (Page 51)

English | 49
Bosch TCC78K751 | 11/2011
– Calc‘n‘Clean : If you want to descale
and clean the appliance at the same
time, press o start/stop (10) and run
the Calc‘n‘Clean programme (see
“Calc‘n‘Clean”).
– Water hardness : Press the arrow button
p . Turn the knob to select the re-
quired water hardness (1, 2, 3 or 4) (refer
also to “Checking and setting the water
hardness”).
– Coffee temperature : Press the arrow
button p . Turn the knob to set the coffee
temperature.
– Auto off after : Press the arrow button p .
Turn the rotary knob to enter the time
span after which the appliance should
automatically switch off following the
last drink preparation. A time between
5 minutes and 8 hours can be set. The
default time is one hour, but this can be
shortened to save energy.
– Illumination : Press the arrow button p .
The lighting can be set to Off , On (factory
setting) or Off after 5 min .
– Tone : Press the arrow button p . The
audible signal you hear when a button is
pressed can be switched OFF or ON by
turning the rotary knob .
– Contrast : Press the arrow button p . The
display contrast can be set from –20 to
+20 with the rotary knob . The default
setting is 0.
– Water filter : Each time a new water i lter is
inserted in the water tank (14), it must be
rinsed:
1. Place the water i lter in the water tank
(14) and i ll the tank with water up to
the “max” mark.
2. Press the arrow button p
[ Start with O ]
and press o start/stop (10).
3. Place a container with a capacity of 0.5
litres under the milk frother (12).
4. Press o start/stop (10). Water will now
run i rst through the i lter to rinse it and
then into the container.
Empty the container. The appliance is
ready to use once more.
Rinsing the i lter simultaneously activates
the setting for the Service - change filter
display.
The i lter is no longer effective when the
Service - change filter display appears,
or at the latest after two months. It needs
to be replaced for reasons of hygiene and
so that there is no build-up of limescale
(this could damage the appliance).
Replacement i lters can be obtained
from retailers or customer service (see
“Accessories”).
After every i lter change the i lter must i rst
be rinsed. Proceed as described at the
beginning of this section.
If no new i lter is used, turn the water i lter
setting to Off .
You can i nd detailed information
about the water i lter in the en-
closed i lter instructions.
If the appliance has not been used
for a prolonged period (e.g. during
your vacation) the i lter should be
rinsed before the appliance is used
again. To do this, simply dispense a
cup of hot water.
– factory settings : You can cancel your own
settings and reset the factory settings. To
activate the factory settings, press o start/
stop (10).
TCC78K751_Heft1.indb 49 15.11.2011 10:15:19