AEG LAVAMAT 54840 - Manual (Page 38)

Water inlet
This appliance must be connected to a cold water supply.
1. TConnect the water inlet hose supplied with the
machine to a tap with a 3/4" thread. Always use
the hose supplied with the appliance.
2. The other end of the inlet hose which connects to the machine can be turned
as showed in the picture.
Do not place the inlet hose downwards. Angle the hose to the left or
right depending on the position of your water tap.
3. Set the hose correctly by loosening the ring nut.
After positioning the inlet hose, be sure to tighten
the ring nut again to prevent leaks.
The inlet hose must not be lengthened. If it is too
short and you do not wish to move the tap, you will
have to purchase a new, longer hose specially designed
for this type of use.
Water drainage
The end of the drain hose can be positioned in three ways:
Hooked over the edge of a sink using the plastic hose guide supplied
with the machine.
In this case, make sure the end cannot come unhooked when the machine is
emptying.
This could be done by tying it to the tap with a piece
of string or attaching it to the wall.
In a sink drain pipe branch. This branch must be
above the trap so that the bend is at least 60 cm above
the ground.
Directly into a drain pipe at a height of not less
than 60 cm and not more than 90 cm.
The end of the drain hose must always be ventilated,
38 Installation
HEC0025
132970011.qxd 23/04/2009 10.25 Pagina 38