Atlantis A02-RA241-W54 - Manual (Page 24)

ENGLISH
24
the modem flash and it reboots
with factory default settings.
Please Switch off device and after
Switch on again.
POWER (jack)
Connect the supplied power
adapter to this jack.
POWER Switch
A Power ON/OFF switch.
1.4 Cabling
First you must connect the product to the ADSL line through
the RJ11 cable you have in equipment (in the port LINE),
then connect to the RJ45 ports the PCs of your Lan or
others Switch. You can get to the Wireless Router through
the different client wireless compatible with the IEEE802.11b
& IEEE802.11g standard. In the end connect the AC Adapter
to the Wireless Router ADSL2+ and then to the socket.
Once you’ve checked all the connections and you’ve
switched on the Wireless Router ADSL2+ the product will
carry on immediately a diagnosis (60 seconds). Finished this
the Led PWR, SYS (eventually even the Led LAN, if
connected to PCs) will be fixed green (WLAN is blinking
when wireless module is loaded) . The Led ADSL, if suitably
connected, at first will be flashing and then it will remain
fixed.
1.5 Default Settings
The Wireless Router ADSL2+ can be configured with your
Web browser. The web browser is included as a standard
application in following operation systems, UNIX, Linux, Mac