Completing the installation – Audiovox Exclusive EX-6000 User Manual

Page 8

FEATURE

ACTION TO PERFORM

RESPONSE FROM SYSTEM

LED FLASH PATTERN

Turn the Ignition Switch ON

LED Turns OFF

Enter

Toggle the Valet/Program/Manual Override Switch

The

ON then OFF 3 Times

1 Siren/Horn Chirp & 1 LED Flash

ProgramminWithin 3 seconds,
Mode

turn the Ignition Switch OFF, then ON

1 Short Chirp, and 1 Long Chirp

First

Press Transmitter Lock/unlock Button to Adjust Feature 1 Chirp = Passive Arming ON

1 Flash, Pause, Repeat

2 Chirps = Active Arming ON

Second

Press Transmitter Lock/unlock Button to Adjust Feature 1 Chirp = Ign Locking ON

2 Flashes, Pause, Repeat

2 Chirps = Ign Locking OFF

Third

Press Transmitter Lock/unlock Button to Adjust Feature 1 Chirp = Ign Unlocking ON

3 Flashes, Pause, Repeat

2 Chirps = Ign Unlocking OFF

Fourth

Press Transmitter Lock/unlock Button to Adjust Feature 1 Chirp = Passive Doorlock ON

4 Flashes, Pause, Repeat

2 Chirps = Passive Doorlock OFF

Fifth

Press Transmitter Lock/unlock Button to Adjust Feature 1 Chirp = Chirps ON

5 Flashes, Pause, Repeat

2 Chirps = Chirps OFF

You have now engaged the Programming Mode, and are set to adjust the First feature

This mode will time out automatically in 15 seconds, or can be cancelled by turning the Ignition Switch OFF

Toggle the Valet/Program/Manual Override Switch once to Advance to the next feature

Turn the Ignition Switch OFF to exit the Programming Mode

NOTE:

If you accidentally toggled past the feature you intended to adjust, you must exit and re-enter the mode.

Toggle the Valet/Program/Manual Override Switch once to Advance to the next feature

EX-6000.

COMPLETING THE INSTALLATION:

After you have confirmed the operation of the EX-6000, and tested any and all optional features of the
system:

1. Mount the control module up and behind the dash securing it in place with cable ties or screws. Be

certain that the chosen mounting location will not inhibit any of the controls of the vehicle.

2. Securely harness and tie all wiring up and away from all hot and moving parts that they may come in

contact with under the dash board or in the engine compartment areas.

CAUTION:Particularly avoid the area around the steering shaft and column, as wires can wrap around

these mechanisms and impair the safe operation of the vehicle.

3. Check the vehicle's wipers, lights, horn, etc... to insure proper operation.
4. Replace all panels that were removed during installation, and retest the system.
5. Explain the operation of the system and its various features to the end user if available, and place the

Owner's Manual on the dashboard for them to find and review.