Perma Pure Indi-GASS - Manual (Page 8)

GASS Module User Manual
8 Bulletin #217
3 Installation
(see Figure 2 for reference.)
3.1 Mounting
Unit should be shielded from direct rain and snow. Do not install outdoors if
temperature will fall below -10°C.
1. Module must be arranged on vertical surface with filter section on top and
dryer sample outlet/purge inlet on bottom.
2. Remove mounting clamps from GASS Module.
3. Mount to rigid surface through mounting slots (spaced 2 5/8" apart).
4. Place GASS Module into clamps and secure.
3.2 Electrical Connections
GASS Module is equipped with two separate heater assemblies. One heater is located
on top portion (filter section) and other heater is placed on bottom portion (dryer
section). Both heaters require an AC power source.
A. Filter Section
Filter Heater Connection
1. Locate 5 pole connector (labeled “Filter Heater Connection”). These wires
are connected to a thermostat in filter section that is pre-set to 90°C.
2. Connect heater wires to 115 VAC or 230 VAC power source (see Figure 3).
Figure 3
110 VAC 220 VAC