beautypg.com

Nm-kickamp-40, Setup procedures – NetMedia kickAMP-40 User Manual

Page 2

background image

NM-kickAMP-40

NetMedia, Inc., 10940 N. Stallard Place, Tucson, Arizona 85737 (520) 544-4567 Fax: (520) 544-0800 Email: [email protected] www.netmedia.com

MAN-kickAMP-40 REV0907A

Setup Procedures:

1. Connect each speaker wire’s “+” and “-” leads to the kickAMP’s Left and Right Speaker Output “+” and “-” termi-

nals. Tighten the terminal screws to secure the connections. You may also detach the quick-connectors from the
amplifier assembly to aid installation or to easily move the unit between locations. To avoid damage to speak-

ers, ensure that they are rated to safely handle the amplifier’s 20 Watt per speaker maximum output.

2. Make sure the audio source has a volume control and that the volume is set to a low level. Insert one

end of the Audio Cable’s 3.5mm plug into the kickAMP’s Audio Input connector. Insert the other end of the
Audio Cable into the audio source’s headphone or speaker output.

3. Connect the 24V DC 2A power transformer to the kickAMP’s Power Input connector. Connect the other end of

the power transformer to an AC outlet; you must connect the transformer to the kickAMP before plug-

ging it into the AC outlet.

4. Start the audio source and slowly increase the volume to the desired level.

Figure 1 - Connecting the kickAMP to power, speakers, and various audio sources such as a portable media player,

a musical instrument, or a laptop computer.

NM-kickAMP-40

Portable Media

Player

kickAMP™

POWER

Musical Instument

Laptop Computer

Speaker

Speaker

+

- +

-

You must connect the

power transformer to the

kickAMP before plugging

it into the AC outlet.

Audio

Cable