Diamond Products GDS60 - Manual (Page 6)

Technical Information
Weight (without blade and support) --------- 29.8 lbs. / 12.5 kg
Width ------------------------------------------------ 10-1/4 in. / 260 mm
Height (without the blade and support) ----- 19 in.. / 483 mm
Length (without the blade and support) ----- 26 in. / 660 mm
Power Requirement__________________ Gas (2-stroke)
-Engine: Dolmar 64cc head
Power Requirement ----------------------------- Hydraulic
Maximum flow: 8 GPM / 30 l/min.
Maximum pressure : 2500 PSI / 172.5 bar
Maximum blade diameter ---------------------- 20 in. / 510 mm
Maximum cutting depth with 16" blade ----- 12 in. / 300 mm
Maximum cutting depth with 20" blade ----- 16 in / 407 mm
Cooling of blade ---------------------------------- Water cooled only (no dry cutting allowed)
Troubleshooting
Saw will not start turning ----------- Confirm power supply is on and hoses are connected correctly.
Accumulation of slurry preventing the saw from turning, clean drive
wheels.
Seized blade guide rollers, replace.
Sparks coming from the side
of the blade while turning ---------- Inadequate water flow or pressure, check water lines/water supply.
Clogged water injection plate.
Blade turning too slow -------------- Inadequate hydraulic flow, check power supply.
Seized blade guide rollers.
Blade loose ---------------------------- Re-set guide bearing cover
Gearbox is hot ------------------------ Not enough oil in gearbox.
Too much oil in gearbox.
Water in oil.
Blocked case vent.
On/Off handle sticking ------------- Broken plunger o-ring.
Bent plunger rod.
Hydraulic oil leak -------------------- Damaged or loose hydraulic fittings.