AeroGarden 100710-BSS - Manual (Page 12)

• Water Low
When light blinks add
water up to “Fill To Here.”
• Add Nutrient
(Feed garden - Basic Feeding)
When “Add Nutrient” and “Water
Low” lights start blinking (every 2
weeks), add 2 nutrient tablets* and
fill the Bowl with water up to “Fill
to Here.” Press and release “Reset”
button to restart nutrient timer and
turn off blinking lights.
*see tending & Harvesting guide for
plant-specific nutrient information.
• Replace Grow Bulbs*
When light blinks (after 6 months
of use), it is time to replace Grow
Bulbs. Bulbs can be ordered at
www.aerogardensupport.com or
from your retailer. After replacing
Grow Bulbs, press “Reset” button
to restart grow bulb timer and turn
off flashing light.
note: if you store your aerogarden
Pro 100 between uses, grow bulb
timer automatically stops when
Pro 100 is unplugged.
*see complete replacement
instructions on next page.
• Adaptive Intelligence
The green light tracks garden
growth from germination
through maturity. AeroGarden
PRO 100 automatically adjusts
the amount of light and water
plants receive to provide op-
timal growing conditions for
every stage of a plant’s life.
note: the time of day your lights turn
off may change as your garden
matures.
• Lights On/Off
Use to occasionally override built-in light timer. Once pushed, lights
will stay off/on until the next time built-in light timer is set to go on/off.
This will not affect the timing of your light cycle and occasional use of
this feature will not harm your plants.
AeroGarden PRO 100 Control Panel
Basic Reminders About Your AeroGarden
• Remove Bio-domes
When plants appear through hole in
Seed Pod Labels, remove Bio-Domes
and discard or recycle.
note: never remove Seed Pod Labels.
11