AEG LAVAMAT LN 79689A3 - Manual (Page 34)

3. Set the hose correctly by loosening the
ring nut. After positioning the inlet
hose, be sure to tighten the ring nut
again to prevent leaks.
4. Connect the hose to a tap with a 3/4”
thread. Always use the hose supplied
with the appliance.
The inlet hose must not be lengthened. If it is
too short and you do not wish to move the
tap, you will have to purchase a new, longer
hose specially designed for this type of use.
Note ! Check if the water connections are
tight.
Installation should comply with local water
authority and building regulations require-
ments. Check the minimum water pressure
required for safe operation of the appliance
in the chapter "Technical Data".
Water-stop device
The inlet hose is provided with a water stop de-
vice, which protects against damage caused by
water leaks in the hose which could develop due
to natural ageing of the hose. This fault is shown
by a red sector in the window «A». Should this oc-
cur, turn the water tap off and refer to your Serv-
ice Centre to replace the hose.
Water drainage
The end of the drain hose can be positioned in three ways:
1. Hooked over the edge of a sink using the plastic hose guide supplied with the
machine.
In this case, make sure the end cannot come unhooked when the machine is emptying.
A
34 Installation