Multichannel Systems ADPT-NN-64 (Revision 5) - Manual

Multi Channel Systems
MCS GmbH
Aspenhaustrasse 21
72770 Reutlingen
Germany Fon +49-7121-9 09 25- 0
Fax +49-7121-9 09 25-11
[email protected]
www.multichannelsystems.com
© 2014 Multi Channel Systems MCS GmbH
Product information is subject to change without notice.
ADPT-NN-64 (Revision 5)
Adapter for connecting two MPA32Is to the
Acute 64 Probe (Revision 5) from NeuroNexus Technology
Top Side
PCB Top View (Probe on the bottom side)
°
°
1
2
1 2
°
°
2 1
1
2
Top Side
MPA32I
No. 1
MPA32I
No. 2
ADPT-NN-64
Acute 64 Probe (NeuroNexus Technology)
Adapter Top Side
Adapter Bottom Side
Direction
of the ----->
Electrodes
Schematic diagram :
Connect the male pins at the bottom side of the Acute 64 Probe to the female pins at the bottom side of the adapter
ADPT-NN-64.
Connect the upper output pins at the top side of the adapter ADPT-NN-64 to the MPA32I No.1. It is mandatory, that
the top side of the MPA32I No.1 faces upwards. (The side with no screws is considered the top side of the MPA32I).
Connect the lower output pins at the bottom side of the adapter ADPT-NN-64 to the MPA32I No. 2. The top side of the
MPA32I No. 2 must face upwards to the bottom side of the MPA32I No.1, otherwise the preamplifiers will not work.
Acute 64
Probe
ADPT-NN-64
MPA32I No. 1
MPA32I No. 2
Acute 64 Probe Electrodes
ADPT-NN-64
Warning: The ADPT-NN-64 Revision 5 may only be used together with the MPA32I
from Multi Channel Systems MCS GmbH and only for the specified purpose.
Damage of the device and even injuries can result from improper use.
!
For the pin layout of the 64-electrode NeuroNexus probe, please see:
http://www.neuronexustech.com/images/Electrode Site Map/A64 Maps.pdf