Multichannel Systems STG-Lite Manual - Manual (Page 20)

STG-Lite Manual
16
Amplitude
Select the amplitude of the pulse. The unit is millivolt (mV). Click onto the red point of the control
dial and move it while keeping the left mouse button pressed. The exact value of the amplitude
will be displayed below the control dial.
Pulse Pattern: Single or paired pulses
Select the stimulus pulse pattern: "Single". You can select single or paired pulse. If you select
"single pulse", you have to define the frequency (Hz) for the single pulses from the drop down
menu. You can program frequencies between 1 and 100 Hz.
If you select "paired pulses" you have to define the frequency for the paired pulses and the "IPI",
the inter pulse interval from the drop down menus. You can program inter pulse intervals
between 1 and 100 ms.
Pulse Pattern: Pulse Trains
Select the stimulus pulse pattern: "Train". You can define the number of pulses, the frequency
of the pulses (Hz), and the number of bursts from the numeric up-down boxes. The interval (s)
can be changed by overwriting the digit in the box. The numeric up-down boxes have values
from 1 to 100, the interval is limited between 0.1 seconds and 16.6 minutes.