MPM MOD-04 - Manual (Page 19)

1
GB
- Holding the plastic flange remove it from the slide. After removing the bag from the container,
hold the bag in the vertical position (by the plastic flange with an inlet hole), remove the latch
placed at the bottom of the bag
Notice! After removing the latch, litter will fall out immediately. This activity must be done over
a dustbin!
- Place the dust bag in the container, placing the plastic flange on the slide with the arrow indicator
pointing down
Notice! Filling level of the dust bag is indicated by the indicator (5) placed in the upper part of the
device, on the accessories container's cover. If the dust bag is filled to capacity, the indicator will
switch to red.
Cleaning and rePlaCing air filters
From time to time, in the course of normal operation, it is required that the motor covering filter and
the air outlet filter be replaced or cleaned. Switch off the device and remove the suction pipe.
1. To clean the air outlet filter (14), press the filter cover locking button (13) located at the back of
the device and remove it carefully from the casing. Carefully remove the filter’s frame. Clean the
filter with water and detergents and dry thoroughly.
To clean the motor’s filter, open the upper cover of the device by pressing the button (12), remove the
bag and carefully slide out the frame and the filter upwards. Remove the filter from the frame and
clean with running water and detergent and dry thoroughly