MPM MLO-03 User Manual

Page 10

USING YOUR CURLING IRON

1. Plug the appliance into the mains and wait for a few minutes to allow it to reach its wor-

king temperature.

2. Hair should be dry or very dry.Separate the stands of to be curled gently brush it free of

tangles. Wrap the hair around the barrel using your hand as a guide and then wind the

bareel towards the scalp exactly as you would when using a roller. Hold it in place for

10-20 seconds and then gently unwind it.

3. Holding it in position for just 5-10 seconds will create gently waves.To achieve extra

bounce and body lift several strands of hair and gently run a brush through them from

scalp to the hair ends.

4. This appliance is suitable for natural and bleached or color hair. Fine or bleached hair

should need only 10-20 seconds wrapped around the barrel to achieve good results,

coarse hair may need a little longer. In practice a little experimentation and experience

will give the desired results whatever the hair type.

5. This appliance can be used on natural hair wigs.

6. Do not however use it on artificial hair wigs or hairpieces as these may melt in the heat

generated by the barrel.

7. Do not use on hair which has beed treated with lacquer or setting lotion as this can stick

to the barrel, reducing its efficiency.

8. After the curler has cooled down it may be hanged due to the hanger (8).

CLEANING

1. Unplug the appliance and allow it tofully cool down before cleaning.

2. Clean with a damp cloth or sponge using mild soap.Do not use harsh detergents, solvents

or abrasives.

3. Do not immerse this appliance in water or any other liquid to clean it.

4. Dry thoroughly before use.

TECHNICAL DATA

Power supply: 16 W

Voltage: 220-240 V 50/60 Hz