MPM MMW-01 - Manual (Page 13)

1
GB
8
5
1
2
3
4
6
7
9
10
DESCRIPTION OF THE APPLIANCE
1. ON/OFF switch
2. Upper ceramic edge
3. Lower ceramic edge
4. Comb
5. Brush to clean the appliance.
6. Cutting accessories
7. A ring used to regulate the length of cutting (5 regulation levels)
8. Charger
9. Control light signaling connection to the network and correct operation of the appliance (red)
10. Charging socket
CHARGING
- Before the first use of the appliance it must be charged for 8 hours at least.
- Before first charging make sure that the appliance is switched off.
- Plug the DC rectifier to mains (11).
- Than, insert the DC rectifier’s plug (9) in the feeding socket.
- A lamp will light on signalizing the appliance is plugged (10); it informs that the appliance is
being charged.
Note:
- The appliance is adjusted to be charged on by the DC rectifier under 230V.
- Do not charge the battery more than 24 hours.
- The appliance is equipped with NiMH battery without so called ‘memory effect’ which means it
may be charged when it is being operated.
- Totally charged appliance may operate without a power approx. 30 minutes.
- At a moment the appliance starts operating slowly plug in the charger in order to charge the
appliance on.
MMW-01.instrukcja.indd...13 2011-02-04...13:33:19