MPM MGM-01 - Manual (Page 16)

operation time will guarantee maximum satisfaction when using the
device.
1. Remove the cap protecting the shaving foil (1).
2. Switch the device on with the switch (9).
3. The best shaving effects can be achieved, when: shaving is always
done before washing the face, the shaver is held by the skin at the
appropriate angle (90’), the skin is stretched and shaving is perfor-
med against the hair.
4. In order to trim whiskers, beard and moustaches protrude the
trimmer for longer hair (7) by pressing the button (8).
CLEANING AND MAINTENANCE
The shaver head (3) is adapted for cleaning with running water
NOTE!
Before cleaning the shaver head in water, the plug must be pulled out of
the shaver socket (11).
Regular cleaning of the shaver assures better shaving results. Rinsing
the head with running water after each shaving session enables to keep
cleanness of the device and has influence on its durability.
1. Switch the device on and rinse the head with a stream of hot running
water. You may use a liquid soap for cleaning. Afterwards rinse the
soap foam off and wait for a moment before switching the device off.
NOTE:
When cleaning the head with running water, the device must be unplug-
ged from the mains supply!
2. Switch the device of with the switch (8)
3. Press simultaneously two buttons releasing the head (6) and pull it
upwards
4. Before putting all the parts together wait till they get dry.
5. Lubricate the trimmer for longer hair (7) and the shaving foil (2) with
a small amount of machine oil on regular basis.
In case of damaging the shaving foil, it should be replaced by pressing
simultaneously two buttons (5) located on both sides of the head and by
pulling the foil upwards.
16
MGM-01_golarka_nowe zdjecia.indd 16 11-12-08 20:17:41