MPM Kasia 116 - Manual (Page 17)

17
GB
BEFORE FIRST USE
After purchasing and unpacking the appliance, wash all the attachments and accessories in warm
water. The power unit must not be submerged in water or other liquids, but just wiped with a damp
cloth.
DOUGH MIXING FUNCTION
Attach the blender container B1 (fig. B) onto the power unit A (fig. A). Place the mixer container
on the driving shaft of the power unit A1 (fig. A) with the handle pointing towards you, and turn it
anti-clockwise until the clasps snap in place. Then place the kneading attachment F1 in the mixer
container (fig. F). Place the food to be mixed into the blender container, then put on the blender co-
ver B2 (fig. B), turning it anti-clockwise until the fastening clasps snap shut. Once prepared in this
way, the blender is ready to use. Other food products are placed in the blender container through the
opening in the cover and can, if necessary, be pushed, but only using the blender pusher B3 (fig. B).
The blender pusher B3 (fig. B) may also be used for dosing loose and liquid ingredients. The proper
assembly sequence is shown in figures (1, 3, 4, 5).
IMPORTANT! When kneading the dough, ensure that it is not kneaded into a ball as this may da-
mage the appliance.
Recommended speeds: During the initial phase of kneading dough, it is recommended that you
set the speed controller A3 (see fig. 2) in the second or third setting, and only turn it up after a few
seconds of work depending on the type of dough.
CHOPPING FUNCTION
For chopping, use the blender container B1 (fig. B). Attach it in the same way as the dough kneader,
but instead of the metal whisk use the metal knife for meat and vegetables F2 (fig. F). Meat or ve-
getables can be chopped using this attachment. The proper assembly sequence is shown in figures
(1, 3, 4, 5).
Recommended speed: for chopping, use settings 5 – 8 (see fig. 2) or the PULSE function – A7 (fig.
2). Products placed in the blender container through the opening in the cover can, if necessary, be
pushed, but only using the blender pusher B3 (fig. B).
MIXING FUNCTION
Attach the mixer bowl G2 (fig. G) to the power unit A (fig. A) and then twist it anti-clockwise until
the clasps snap in place. Place the ingredients to be mixed into the mixer bowl. Put on the cover G1
(fig. G). The proper assembly sequence is shown in figure 11.
IMPORTANT! Do not fill the mixer bowl with hot liquids.
Do not pour more than 1.0 l of liquids into the mixer bowl.
Recommended speed: set the mixer speed according to the recipe or your own requirements.
WHISK FUNCTION
Attach the whisk head I1 along with the whisk end I2 (fig. I) into the blender container B1 (fig. B) on
the driving shaft A1 (fig. A) and close the blender cover B2 (fig. B), twisting it anti-clockwise until
the clasps snap in place. The proper assembly sequence is shown in figure 7.
Warning:
The whisk can may be used for making foam from egg whites without sugar.
When trying to mix even the most delicate of dough with the whisk, the whisk head I1 may be da-
maged and repair costs are not covered by the warranty.
Recommended speed - best use 7 – 8 speed setting (see fig. 2).