MPM MRK-03 User Manual
Page 15

15
GB
NOTE! This device is equipped in a safety lock that allows switching on the food processor only if the accessories
are correctly assembled to the processing unit.
When the accessories are correctly assembled, a built-in safety lock is unlocked, which allows
you to run the device.
BEFORE FIRST USE
After unpacking, wash all parts of the food processor with hot water; read the user manual
and familiarize with all the parts of the device.
USING THE DEVICE
STIRRING/ KNEADING FUNCTION
Place the container of the food processor
B
on the processing unit
A
in order to place the
handle to the right side of the device. Lock the container by turning it clockwise until it snaps
into the spanners. Place the stirrer for kneading
D2
on the discs driver
A2
in the container of the
food processor
B
. Place the products to be kneaded in the container. Place the lid
B1
and turn
it clockwise until the spanner is locked. Place the pusher
B2
in the lid. If necessary, you can add
products thorough the hole in the lid. After finishing operating, turn the switch
A3
in position
A6
.
NOTE! Do not allow the kneaded dough to form a lump as this may lead to damage of the device. During
operating the use of 1 or 2 speed is recommended,
if necessary.
CHOPPING FUNCTION
Place the container of the food processor
B
on the processing unit
A
in order to place the handle
to the right side of the device. Lock the container by turning it clockwise until it snaps into the
spanners. Place the metal knife for cutting
D1
on the discs driver
A2
in the container of the food
processor
B
. Place the products to be cut in the container. Place the lid
B1
and turn it clockwise
until the spanner is locked. Place the pusher
B2
in the lid. If necessary, you can add products
thorough the hole in the lid. After finishing operating, turn the switch
A3
in position
A6
.
GRINDING AND CUTTING FUNCTION
Place the container of the food processor
B
on the processing unit
A
in order to place the
handle to the right side of the device. Lock the container by turning it clockwise until it snaps
into the spanners. Place the double cutting and grinding disk
C
on the discs driver
A2
in the
container of the food processor
B
. Place the lid
B1
and turn it clockwise until the spanner is
locked. Place the products through the hole in the lid of the food processor pushing it with the
pusher
B2
. After finishing operating, turn the switch
A3
in position
A6
. When operating with
the use of the disk, set the speed in position at the very beginning. Then, if it is necessary,
you may increase the speed to position.
MASHING FUNCTION
Place the food container
B
on the motor unit
A
so that the handle is positioned on the
right side of the appliance. Lock the container, turning it clockwise until the locking clips snap
into place. Mount the mashing disc
C2
on the spindle
A2
in the food container
B
. Apply the
MRK-03_instrukcja_v02.indd 15
2012-07-27 08:56:57