MPM MGO-08M - Manual (Page 10)

10
GB
PRIOR TO THE fIRST USE:
1..Prior to the first use of the roaster, thoroughly wash the heating panels of the roaster/waffle-maker
with the cloth moistened with warm water and thoroughly wipe with dry cloth thereafter.
2. Then prior to the first use of the roaster, lightly oil its working surfaces.
3. Close the cover, switch on the roaster for about 10 minutes. After completed heating, switch off
the appliance, allow the panels to cool down and clean them
4. The working surfaces of the roaster are heated up to extremely high temperatures! Touch the
holders only!
5. Stand the appliance on a flat, stable and dry surface which is resistant to high temperatures.
6. When opening the cover, proceed carefully owing to hot damp from the area under the heating
panels!
7. Bread may burn! Therefore the appliance must not be used near or below curtains and in vicinity
of other combustible materials!
USE Of THE ROASTER / WAffLEMAKER
1..Insert the plug into the socket – red caution lamp (power supply) (1) and green caution lamp (ther-
mostat) (2) will go on. Close the cover of the appliance (3).
2. Prepare the sandwiches or dough for waffles.
3. When the green caution lamp will go off, open the cover and put the sandwiches on the heating
panels or carefully pour the dough for waffles. Gently close the cover (3) and clamp with clip (4).
4. When checking the condition of sandwiches in course of their roasting, open the cover carefully
owing to hot damp escaping from the both sides of the roaster!
5. Open the cover and remove roasted sandwiches / waffles using wooden or plastic spatula.
6. Before preparation of the next sandwiches or waffles, always close the cover in order to maintain
required temperature. The green caution lamp (thermostat) will go on and off in course of roast-
ing to indicate that required temperature is maintained.
7. After finished roasting pull out the plug from the plug socket and allow the appliance to cool
completely.
noTe!:
Do not use and metal and sharp knifes or forks, otherwise the damages of heating surfaces
are possible!
cLeaning and MainTenance
1..Prior to commencing the cleaning (and after finishing the roasting), pull out the plug from the
plug socket and allow the appliance to cool completely.
2. Thoroughly wash the heating panels, clean the roaster edges using soft cloth or towel.
3. If complete removal of any food residuals from the surface of heating panels is problematic, pour
some edible onto dirty surface and try to clean after about 5 minutes. Your efforts will be success-
ful this time.
4. Wipe the external surface of the roaster using wet cloth.
mop-08M_mgo-08M_instrukcja.indd...10 2010-10-27...10:59:57