En gl is h, Display illumination, Power save – MIDLAND G9 User Manual

Page 19: Battery recharge

buttons.

Confirm your selection by pushing

PTT or wait for 5 seconds.

Display illumination

If there is insufficient light to read the display, press briefly

EMG

and the display illumination will activate for about

5 seconds. Every time the

MENU is pressed, the display will automatically light up.

Power save

The battery power saving feature enables a reduction in the consumption of up to 50%; power saving comes on

automatically when the transceiver does not receive any signal for more than 7 seconds. When the batteries are

discharged, the icon

CALL

MENU

EMG

8 7

12
13
14

appears on the display: replace the batteries or recharge the battery pack.

! The power save is active only if the Emergency function is disabled.

Battery recharge

Connect the socket of the wall adaptor to a mains power socket and insert the jack of the wall adaptor into the

desktop charger plug. It takes 12/14 hours to fully recharge.

Place your transceiver into the cradle of the desktop charger. The red led of the charger will light up.

When charging is complete take the transceiver out of the cradle and detach the socket of the wall adaptor from

the mains.

! Do not overcharge the batteries! When these are fully charged the charging process does not stop

automatically. Do not forget therefore, to remove the transceiver from the charger as soon as the

batteries are charged, otherwise the radio and batteries may be damaged.

! Do not try to charge alkaline batteries or non rechargeable batteries. Make sure that when you charge

the radio, only rechargeable NI-MH batteries or the supplied battery pack should be contained in the

battery compartment! Alkaline batteries are not rechargeable! Batteries which are not suitable to be

recharged may leak, explode or even burn and cause damage!

! Using a different battery charger other than the one specified can cause damage to your device or may

even cause explosions and personal injuries.

! Do not throw batteries into fire or place them near heat as this may cause explosions or personal

injuries. Dispose of the batteries according to the procedures set out by local regulations.

! Do not mix old and new batteries or batteries of different types or batteries which have been used in

different manners.