Problem solving – MIDLAND G11V User Manual
Page 28

10 |
Midland G11V instruction guide
Problem solving
Problem
Possible Cause
Solution
The radio doesn’t
switch on
The battery pack is
discharged and/or
has not been installed
correctly.
Verify that the battery
pack is charged and
that it has been cor-
rectly installed.
The radio switches off
shortly after it has been
switched on
Discharged battery
pack.
Recharge the battery
pack.
The battery pack does
not recharge
The battery-charger has
not been connected or
installed correctly.
Inspect the connec-
tions of the battery-
charger and the instal-
lation of the batteries.
The radio switches on
but is unable to receive
signals
The site of installation
is too shielded.
Move to an another
area.
The volume is too low
Adjust the volume
level.
Incorrect CTCSS or DCS
Check that the CTCSS
tone or DCS code cor-
responds to the one set
by the parties you are
communicating with.
Noise is always present
in reception mode
The Monitor function is
enabled.
Disable the Monitor
function.
It is not possible to
communicate with
other parties
An incorrect radio
channel has been
selected.
Select the same radio
channel used by the
parties you are commu-
nicating with.
The radio is installed
in a shielded area or is
too far from the party
you are communicating
with
Move to another area.
Incorrect CTCSS or DCS
Check that the CTCSS
tone or DCS code cor-
responds to the one set
by the parties you are
communicating with.