MIDLAND BTX2 FM - Manual (Page 19)

18 - Midland BTX2 FM
UK
To pair the BTX2 FM to another BTX2 FM unit, you must first enter the setup mode:
1. Turn off the unit
2. Press and hold down the middle button about 7 sec., until the Red light is
on permanently.
3. Now press the Middle or the Backward button for 3 seconds. The Blue and Red
light will flash.
4. Do the same procedure on the other unit, When successfully paired, each
unit will have the Blue light on for one second and than go back to the setup
mode (Red light always on).
5. Now the pairing procedure is complete, you just need to exit the setup
mode before you can use the units:
Double click on the Middle button, the Red light will turn off and the
Blue light will start flashing.
You can use now your BTX2 FM.
Unit already busy
If you try to open a intercom connection to another person that is already busy
talking with some one else (or is in a middle of a phone conversation), you will
hear a “busy” double beep tone. Just wait sometime and try again, maybe this
time the “line” is not busy.
The person who is called, will be advised that someone is trying to call and will
hear a voice announcement with the number of the button from which the re-
quest is coming.
Talk 2 All - Pairing to a different brand intercom
Thanks to the “Talk2 All - Universal Intercom” feature it is now possible to pair your BTX2
FM to a different brand intercom available on the market, using “Forward button”
1. On the BTX2 FM enter the setup mode: (With the unit OFF press and hold down the
Middle button about 7 sec., until the Red light is on permanently.
2. Press the “Forward” button for 3 seconds, the Red and Blu LED light will flash.
3. On the other intercom (not Midland brand) follow the procedure to pair to a phone.
Attention: remember to switch off all the other Bluetooth device, only the two
devices involved in the pairing must be turned on.
If successfully paired the red/blue light will stop flashing and the blu light will
slowly flash instead.
To open the intercom communication on the BTX2 FM press forward button.
On the other intercom just press the phone redial button.
Maybe it will be necessary to press the dial button two times, depending on the model
of the not Midland intercom.
Attention: when using this configuration, the other intercom (not Midland brand) will
not be able to be paired to a phone.
Pairing the BTX2 FM to Bluetooth devices
The BTX2 FM unit can be paired to other Bluetooth devices, like Phone, GPS Navi-
gator or PMR446 Radio with built-in or external Bluetooth (dongle). The pairing
procedure must be done using the “Volume +” or the “Volume -“ buttons.
› Pairing to the “Volume +” button: for Phone with music A2DP stereo, GPS Na-
vigator with A2DP audio or external mono/Stereo A2DP dongle.
› All devices paired to “Volume +” button has higher priority and will interrupt
all the other communication (like Intercom, FM Radio and Music).
› Pairing to the “Volume -” button: for a second phone with mono audio (Hands
Free Protocol) for GPS navigators/ Radar detector and other devices which
mono audio.
2 3
Talk2All - Universal Intercom
Dispositivo non Midland
Driver 1
Driver 2
Passennger 1