MIDLAND Atlantic XT - Manual (Page 22)

6
ENGLISH
4. Preparing the transceiver
Make sure the following items are supplied in the package
before you start using your transceiver:
• transceiver;
• desk/wall support;
• belt clip holder;
• waterproof case with neck collar
• operational manual;
If any of the above is missing or damaged contact your
supplier immediately.
4.1 Installing and removing the belt clip
With the belt clip you can easily attach the transceiver to your
belt. The clip however, must be removed in order to install
or change the batteries. To remove the belt clip follow the
instructions of picture 1. To fix the clip back to the device slot
it in the guides at the back of the transceiver until it clicks
into place.
4.2 Installing and removing batteries
The transceiver is operated by four optional AA battery. These
can be either one of two types:
• Rechargeable NiMH (1,2 V) - available in different capacity
(in mA/h). Batteries with higher capacity will supply longer
charger but will require longer times to recharge.
• Non-rechargeable alkaline (1,5 V)
!
Do not install rechargeable and alkaline batteries at
the same time in your transceiver. Always use the
same batteries as a set (type and make) so that you
can be sure their level of charge is the same.
!
If you do not use the transceiver for a long time remo-
ve the batteries.
4.2.a Installation
1) Remove the belt clip as explained in paragraph 4.1;
2) Open the batteries compartment as shown in picture 2;
3) Insert the batteries in the battery compartment as shown
in picture 2.
4) Replace the cover on the batteries compartment.
5) Replace the belt clip.
!
Be careful to insert the batteries according to their po-
larity as illustrated inside the compartment
!
Be careful to snap close the battery cover.
Picture 1
Picture 2