Mody Pumps G 706 T_316SS - Manual (Page 10)

13. SLIDE ON WEAR PLATE AGAINST LOWER BEARING BRACKET AND TIGHTEN THE SAME. FIT
KEY (35) ON THE SHAFT AND SLIDE ON IMPELLER. CLEARANCES BETWEEN IMPELLER AND
WEAR PLATE CAN BE ADJUSTED BY MEANS OF THE TRIMMING SPACERS (37). SLIDE ON LOCK
WASHER (34) ENSURING THAT TONGUE OF LOCK WASHER IS IN GROOVE OF THREADING AND
TIGHTEN NUT (33). BEND LOCK WASHER OVER ANY SIDE OF THE HEX NUT. ENSURE THAT
ROTOR SHAFT IS ROTATING FREE.
14. FIT OUTER CASING ON TOP BRACKET WITH "O" RING. FIT DIFFUSER RING AND
DIFFUSER HOLDER AND TIGHTEN NUTS. FIT DIFFUSER CENTER AND ADJUST CLEARANCE
BETWEEN IMPELLER AND DIFFUSER CENTER TO THE MINIMUM BY USING TRIMMING WASHERS
(30). FIX STRAINER, BASE PLATE AND TIGHTEN BOLTS (28)
OIL SPECIFICATIONS
A). SHELL TELLUS 29.
B). EXXON UNIVOLT 61
USE FDA APPROVED NON-CONDUCTING, NON-FOAMING, NON-
DETERGENT OIL ONLY
PARTS CATALOG
.
1. COMPONENTS LIST : AS PER DRAWING # DW/207/00 (SHEET 1 & 2)
DRAWINGS :
1. SECTIONAL ASSEMBLY DRG. NO.DW/207/00(SHEET 1)
2. SEALING ARRANGEMENT WITH MATERIAL PARTS LIST NO. DW/207/00(SHEET 2)
R: RECOMMENDED SPARES FOR TWO YEARS OPERATION
SR.NO DESCRIPTION PART NO. QTY.
1. MECHANICAL SEAL 535-034-00 2 NO.
2. "O" RING SET 375-025-66 2 SETS.
3. CABLE GROMMET 260-076-66 2 NOS.
4. CABLE LEAD GROMMET 260-068-66 2 NOS.
5. UPPER BEARING 020-007-07 1 NO.
6. LOWER BEARING 020-009-07 1 SET.
7. IMPELLER(G702T/60 HZ) 300-054-24 1 NO.
8. DIFF. CENTER(G702T) 155-011-24 1 NO.
9. DIFFUSER RING(G702T) 170-011-24 1 NO.
10. WEAR PLATE 715-015-24 1 NO.
11. LOCK WASHER 695-005-21 2 NOS.
PLEASE CHOOSE IMPELLER/DIFFUSER SET ACCORDING TO PUMP MODEL &
FREQUENCY.