Mody Pumps G 706 TM - Manual (Page 10)

13. SLIDE ON WEAR PLATE AGAINST LOWER BEARING BRACKET AND TIGHTEN THE SAME. FIT
KEY ON THE SHAFT AND SLIDE ON IMPELLER. CLEARANCES BETWEEN IMPELLER AND WEAR
PLATE CAN BE ADJUSTED BY MEANS OF THE TRIMMING SPACERS. SLIDE ON LOCK WASHER
ENSURING THAT TONGUE OF LOCK WASHER IS IN GROOVE OF THREADING AND TIGHTEN NUT.
BEND LOCK WASHER OVER ANY SIDE OF THE HEX NUT. ENSURE THAT ROTOR SHAFT IS
ROTATING FREE.
14. FIT OUTER CASING ON TOP BRACKET WITH "O" RING. FIT DIFFUSER RING AND
DIFFUSER HOLDER AND TIGHTEN NUTS. FIT DIFFUSER CENTER AND ADJUST CLEARANCE
BETWEEN IMPELLER AND DIFFUSER CENTER TO THE MINIMUM BY USING TRIMMING WASHERS.
FIX STRAINER, BASE PLATE AND TIGHTEN BOLTS.
OIL SPECIFICATIONS
A) EXXON UNIVOLT 61
B) SHELL TELLUS 29.
C) CHEVRON SUPERLA FDA APPROVED # 10
USE NON-CONDUCTING, NON-FOAMING, NON-DETERGENT OIL ONLY
PARTS CATALOG
.
1. COMPONENTS LIST : AS PER DRAWING NO. DW/042/00 (SHEETS 1 & 2) AND
DW/043/00 (SHEETS 1 & 2)
DRAWINGS :
1. SECTIONAL ASSEMBLY DRG. NO.DW/042-043/00 (SHEET 1)
2. SEALING ARRANGEMENT WITH MATERIAL PARTS LIST NO. DW/042-043/00 (SHEET 2)
R: RECOMMENDED SPARES FOR TWO YEARS OPERATION
SR.NO DESCRIPTION PART NO. QTY.
1. MECHANICAL SEAL
535-020-00 2 NO.
2. "O" RING SET 375-025-66 2 SETS.
3. CABLE GROMMET 260-066-66 2 NOS.
4. CABLE LEAD GROMMET 4 HOLE 260-104-66 2 NOS.
5. UPPER BEARING
020-007-07 1 NO.
6. LOWER BEARING 020-009-07 1 SET.
7. IMPELLER(G702T/60 HZ) 300-054-22 1 NO.
8. DIFF. CENTER(G702T) 155-001-80 1 NO.
9. DIFFUSER RING(G702T) 170-002-80 1 NO.
10. WEAR PLATE 715-015-80 1 NO.
11. LOCK WASHER 695-005-21 2 NOS.
PLEASE CHOOSE IMPELLER/DIFFUSER SET ACCORDING TO PUMP MODEL &
FREQUENCY.