Mody Pumps G 906 T User Manual
Page 10
13. SLIDE ON WEAR PLATE AGAINST LOWER BEARING BRACKET AND TIGHTEN THE SAME. FIT
KEY (35) ON THE SHAFT AND SLIDE ON IMPELLER. CLEARANCES BETWEEN IMPELLER AND
WEAR PLATE CAN BE ADJUSTED BY MEANS OF THE TRIMMING SPACERS (37). SLIDE ON LOCK
WASHER (34) ENSURING THAT TONGUE OF LOCK WASHER IS IN GROOVE OF THREADING AND
TIGHTEN NUT (33). BEND LOCK WASHER OVER ANY SIDE OF THE HEX NUT. ENSURE THAT
ROTOR SHAFT IS ROTATING FREE.
14. FIT OUTER CASING ON TOP BRACKET WITH "O" RING. FIT DIFFUSER RING AND
DIFFUSER HOLDER AND TIGHTEN NUTS. FIT DIFFUSER CENTER AND ADJUST CLEARANCE
BETWEEN IMPELLER AND DIFFUSER CENTER TO THE MINIMUM BY USING TRIMMING WASHERS
(30). FIX STRAINER, BASE PLATE AND TIGHTEN BOLTS (28)
OIL SPECIFICATIONS
A) SHELL TELLUS 29.
B) EXXON UNIVOLT 61
C) CHEVRON SUPERLA FDA APPROVED # 10
USE NON-CONDUCTING, NON-FOAMING, NON-DETERGENT OIL ONLY
PARTS CATALOG
1. COMPONENTS LIST : AS PER DRAWING NO. DW/149/00 (SHEET 1 & 2)
2. SPECIAL TOOLS :
S.NO. TOOL PART NO. DESCRIPTION QUANTITY
1. T7009 IMPELLER SPANNER(G902T) 1
2. T7010(ALT.) IMPELLER SPANNER(G906T) 1
3. T5204 NOSE PLIER 8" LONG 1
4. T9504 SCREW KEY TYPE "T" 2
5. T9004 SEAL ASSEMBLY MANDREL 1
6. T4102 BEARING PULLER (SCREW LENGTH 4") 1
7. T8006 PULLER FOR STATOR 1
8. T4104 BEARING PULLER (SCREW LENGTH 8") 1