ASA ACC56M - Manual (Page 9)

Changer
Frequency Response 5 - 20,000 Hz ±1dB
Distortion 0.008% @ 1kHz
Dynamic Range 95 dB
Signal-to-Noise Ratio 95 dB
Channel Separation 70 dB @ 1kHz
Wow & Flutter below measurable limits
Dimensions (W) 9 - 6 /8" x (H) 3- 2 /8" x (D) 7 - 1 /8"
(W) 2 50 mm x (H) 8 1 mm x (D) 1 81 mm
Operating Voltage 12 Volts DC, negative ground
Current Drain 800mA (Playback/loading/ejecting)
Accessories Supplied: 10-disc magazine, P/N 10CD56M
Mounting hardware (1set)
Connecting cable (1ea.)
1 5 1 4
SPECIFICATIONS
An error made in operation or during installation of this product may be mistaken for a
system malfunction. Please perform the checks described below before contacting your
dealer or service facility.
T R O U B L E S H O O T I N G
Remedy
Check fuses in vehicle fuse box and
changer system.
Replace as necessary with fuse of
same type and rating as original. If
fuse blows again, consult with
service facility.
Blown fuse
No power
Magazine cannot be
installed
CD is not played
Noise,Skipping,or
intermittent sound
during playback
Radio will not switch
to CDC mode
Set the mounting angle adjustment
to the correct position as per the
installation instructions.
Mounting angle adjustment is not
correct.
Check all wiring and correct as
necessary.
lncorrect connection
Insert magazine in proper direction.
Magazine is inserted in wrong
direction.
Load disc correctly in the magazine.
Check sound on another disc. If
sound from second disc is OK, first
disc is defective.
Scratches on disc or warped disc
Disc is located incorrectly in
magazine
Clean disc
Remove the transit screws from
sides of the unit.
Transit screws still in place
Possible Cause Symptom
Extremely dirty disc
Radio has not been initialized
with the ACC56M attached Press the RESET button on the face
of the radio.