Lectrosonics UCR210d - Manual (Page 10)

FREQUENCY BLOCKS AND RANGES
The table below lists the factory designated frequency ranges avail­
able for the UCR210D receiver. For convenience, the table includes
information about the transmitter antennas as well.
Each UCR210D receiver is built to cover a pre-selected range of
frequencies (a “block”) as shown below. The receiver will tune to
any of 256 different frequencies within this factory assigned block.
The UCR210D UHF Receiver antennas (model A8U) are color
coded to indicate the frequency block that they operate within. The
length of the antenna varies with the frequency block. The actual
length of the antenna is not as critical as it might appear in the table
below. The usable bandwidth of the A8U antennas are +/- 50 MHz
from the center frequency, so it is acceptable to use an antenna
from an adjacent block above or below the operating frequency.
The color of the antenna sleeve is in keeping with standard resistor
value color codes for the second digit of the block number.
FREQUENCY ANT SLEEVE ANTENNA
BLOCK RANGE COLOR WHIP LENGTH
21 537.600 - 563.100 Brown 4.74"
22 563.200 - 588.700 Red 4.48"
23 588.800 - 614.300 Orange 4.24”
24 614.400 - 639.900 Yellow 4.01"
25 640.000 - 665.500 Green 3.81"
26 665.600 - 691.100 Blue 3.62"
27 691.200 - 716.700 Violet (Pink) 3.46"
28 716.800 - 742.300 Grey 3.31"
29 742.400 - 767.900 White 3.18"
30 768.000 - 793.500 Orange/Black 3.08"
31 793.600 - 819.100 Orange/Brown 2.99”
32 819.200 - 844.700 Orange/Red 2.92”
33 844.800 - 865.000 Orange/Orange 2.87”
Whip Length
A8U Receiver Antenna
Whip Length
A6U Transmitter Antenna
10