Lectrosonics CR187 - Manual (Page 10)

CR187
Replacement Parts and Accessories
Part No. Description
CH-12 110 Volt AC adapter for CR187 receiver
A-185 Coax Remote, folded-dipole antenna with
coaxial cable
35753 System pouch
A-195RA Helical, flexible (“rubber duckie”) antenna
with a 9inch whip and a right angle BNC
connector
A-185-BNC Telescoping 1/4 wave whip on a swiveling
BNC connector
Specifications and Features
Operating Frequencies: 150MHz to 216MHz, crystal controlled
Sensitivity: Better than 0.6uV for 20dB quieting without compandor;
1.9uV for 50dB S/N ratio with compandor
Signal/Noise Ratio: 102dB A weighted
Squelch Quieting: greater than 100dB
AM Rejection: -60dB (10uV to 0.1 Volts)
Modulation Acceptance: ±15kHz
Image and Spurious Rejection: greater than 100dB
Third Order Intercept: +6dBm
Audio Outputs: XLR: 200 Ohms balanced; 100mV max.
Headphone: 2 Volts RMS into 100 Ohms
Antenna Input: BNC; 50 Ohms impedance
Controls: XLR front panel output attenuator control
Recessed trim-pot headphone control
3 position power/function switch
Indicators: Red LED for power “ON” (Battery status)
2 LEDs for modulation level
“RF” LED for transmitter “ON”
Power Requirements: 12 Volts DC external (either polarity)
110 VAC via CH-12 AC adapter
Single 9 Volt alkaline battery
Power consumption: 55mA
Battery Life: 5 hours with alkaline
Weight: 11 ounces including battery
Dimensions: 1.1” x 2.75” x 5.2”
Specifications subject to change without notice.
LECTROSONICS, INC. 10