Lectrosonics Venue Series (Wideband) - Manual (Page 19)

Digital Hybrid Wireless™ Modular Receiver System
Rio Rancho, NM, USA 19
2. On the first page of the Wizard, select Install from
a list or specific location (Advanced) and click
“Next>” to continue.
3. Select “Search for the best driver in these loca-
tions.”, then check the box for “Search removable
media (floppy, CD-ROM...)” and click Next > to
continue to the next page.
4. Windows will search the CD for the driver and when
it has found it. If a dialog box opens warning you
that the driver has not passed Windows Logo Test-
ing, click “Continue Anyway.”
Installing LecNet2 ™ Software and USB Driver
LecNet2 software includes VRpanel for easy setup and
monitoring of the Venue Receiver using a computer
system running Windows ® 2000, XP or Vista TM operating
systems.
Installing LecNet2 ™ Software
1. Remove any previously installed versions of Lec-
Net2 ™ software to make sure you are using the
latest release.
2. Insert the LecNet2 ™ program disk supplied with
the Venue Receiver into the CD-ROM drive on the
computer system that will be used for set up and
control.
3. The CD should automatically start the installation
procedure. If it doesn’t, click “Start” on the Windows
Task Bar then click “ Run...” Enter the Drive letter
(“E” in the example) followed by “ :\Setup.Exe” as
shown below.
4. Follow the on-screen instructions to install the
LecNet2 ™ software and the VRpanel for the Venue
Receiver.
Installing the LecNet2 ™ USB Driver
A Venue receiver can be connected to a computer with
a USB cable or an RS-232 cable. Although the USB
port offers increased speed and convenience over
standard RS-232 links, it does require the installation of
a LecNet2 ™ USB driver.
The LecNet2 ™ USB driver is not part of the standard
Windows ® 2000 and XP driver libraries; therefore, con-
necting a computer system to the Venue receiver for the
first time differs from subsequent installations. There are
a few differences between installing the LecNet2 ™ USB
drivers on Windows 2000 versus Windows XP systems.
USB Driver Installation (Windows XP) - First Time
When the VR is connected to a Windows XP computer
system for the first time, the Windows ® Found New
Hardware Wizard automatically opens. Use the follow-
ing procedure to install the LecNet2 ™ USB driver using
the Wizard.
1. Place the LecNet2 ™ Installation Disk in the PC’s
CD-ROM drive.