Ip-00051, Al-d2vw – L-com AL-D2VW User Manual

Page 2

IP-00051 Rev. A – 06/05 Page 1/1

Suppression Module Detail

Self Sealing Screw
Terminals

Ground Terminal

Cable Grommet

Installation Instructions

1. Punch required holes in Cable Grommet and insert wires into protector. (Cable Grommet is removable)

2. Loosen terminal screws on Suppression Module and insert wires as shown (stripping of wires is not required).
Tighten terminal screws to secure wires in suppression module. Suppression Modules can be removed to
ease wiring. Note, unit provides protection to both sides of suppression module equally.

3. Attach ground wire to the Ground Terminal inside the protector (see above).

Grounding Note: To ensure proper operation of the protector, install an earth ground to the ground terminal in
the protector. Please refer to the National Electric Code (or your local codes) for additional information or contact
a licensed electrician for assistance.

4. If mounting this unit to a wall or other surface, break-away holes are provided
on the rear of the unit.

Break-Away Holes

AL-D2VW

L-COM, INC. 45 BEECHWOOD DRIVE NORTH ANDOVER, MA 01845

WWW.L-COM.COM E-MAIL: [email protected] PHONE: 1-800-343-1455 FAX: 1-978-689-9484