L-com WLKIT-G/GI Series Kits - Manual (Page 4)

When locating the antenna or operating this device you must observe the following
exposure limits:
When this device is installed either as a fixed-mount or mobile application there
is a minimum required separation distance of 20 cm from users.
Non-Amplified Systems:
For non-amplified systems simply plug the antenna connector into the antenna port on
the PC card and proceed to PC Card and Software Installation on the next page.
Amplified Systems:
Amplifier connections are clearly labeled on the amplifier unit as shown below.
1. Connect the antenna to the amplifier output labeled “ANTENNA”.
2. Connect the PC Card to the Amplifier input labeled “TO RADIO / DC INJECTOR”
using the pigtail cable.
3. Plug the AC adapter into the amplifier’s DC power jack and wall outlet.
Proceed to PC Card and Software Installation on the next page.
Copyright © This drawing is property of L-com Global Connectivity. All rights reserved.
L-COM, INC. 45 BEECHWOOD DRIVE NORTH ANDOVER, MA 01845
WWW.L-COM.COM E-MAIL: [email protected] PHONE: 1-800-343-1455 FAX: 1-978-689-9484
© L-com, Inc. All Rights Reserved. L-com Global Connectivity and the L-com logo are registered marks.