AEG KO-LAVAMAT 62600 - Manual (Page 18)

18
Run wash cycle
Brief instructions
A washing cycle consists of the following steps:
0 Open the door, put in the washing.
0 Shut the door.
0 Add detergent/conditioner.
0 Set the correct washing program:
– Set the program on the program selector;
– Set the temperature on the temperature selector;
– Select type of washing with the type of washing buttons.
0 Press (ON/OFF) button.
Washing program starts automatically after six seconds. During these
six seconds:
0 Set any delay timer if required.
0 If applicable change final spin speed/select a
(Rinse hold).
You can change this setting and the temperature during the entire
washing cycle.
After the washing program has finished:
Attention! If the washing cycle ends with a (Rinse hold),
run (PUMP OUT) or (SPIN) before opening the door.
0 Open the door, remove the washing.
0 Press the
(ON/OFF)button!