American Access Systems PhoneLink - Manual (Page 4)

Page 4 American Access Systems / Security Brands, Inc.
DOC Requirements
Equipment Attachment Limitations
Notice: This equipment meets telecommunications network protective, operational and safety requirements as
prescribed in the appropriate Terminal Equipment Technical Requirements Document(s). This is confirmed by
markingthe equipment with the Industry Canada certification number. The Department does not guarantee the
equipmentwill operate to the user’s satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local
telecommunications company. The equipment must also be installed using an acceptable method of connection.
The customer should be aware that compliance with the above conditions might not prevent degradation of service
in some situations.
Repairs to certified equipment should be coordinated by a representative designated by the supplier. Any repairsor
alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications
company cause to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power utility, telephone
lines and internal metallic water pipe system, if present, are connected together. This precaution may be particularly
important in rural areas. Caution: Users should not attempt to make such connections themselves, but should
contact the appropriate electric inspection authority, or electrician, as appropriate.
Notice: The Ringer Equivalency Number (REN) assigned to each terminal device provides an indication of the
maximum number of terminals allowed to be connected to a telephone interface. The termination on an interface
may consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalency
Numbers of all the devices does not exceed five.
The abbreviation, IC, before the registration number signifies that registration was performed based on Declaration of
Conformity indicating that Industry Canada technical specifications were metIt does not imply that Industry Canada
approved the equipment.
Parts Checklist
Parts that are included in the box include the following items. If any of the items is missing, contact American Access
Systems (AAS).
1 PhoneLink Unit
1 12VAC Adapter
4 ¼”-20 X ½” carriage bolts
4 ¼”-20 hex nuts
Tools Needed For Basic Installation
• • Wire nuts or appropriate terminals/connectors
• • Wire strippers
• • Wire cutters
• • 3/8” drive ratchet, 6” extension, 7/16” socket
• • Digital or Analog multi-meter
• • Drill
Technical/Customer Support
1-303-799-9757 or
[email protected]