Auto Page CPX-2300 - Manual (Page 2)

CPX-2300 OPERATION MANUAL
TRANSMITTER OPERATION:
Transmitter Button Feature Remark
Button
Arm / Door lock
– Button
Arm and Delete Optional Sensor Press twice within 3
seconds.
Button
Car Locator Under arm mode
Button for 3 seconds
Panic Press & hold 3 seconds
Button
Disarm & door unlock
Button for 2 seconds
In or Out Active/Passive mode Press & hold 2 seconds
+ Button
Silent arm / disarm Under ignition off
+ Button for 2 seconds
Anti car-jacking Under ignition on
A. ACTIVE ARMING – LOCK & ARM:
1. Press button on transmitter.
2. The siren chirps once and parking lights flash once indicating the system is now armed. The
vehicle doors will lock upon arming when interfaced with the security system.
DOOR AJAR WARNING: When you arm the system and the siren chirps 3 times, it means you
have left a door or trunk, or hood lid ajar. You should check and find out the defective protecting
point.
SHOCK SENSOR / OPTIONAL SENSOR BY-PASS: Press
button twice within 3 seconds to
arm the security system, by-pass shock sensor connected to 3-pin plug. The system will chirp one
additional time to confirm the sensor bypass mode was activated. The sensor bypass feature is
programmed to activate for one arming cycle only. The security system will return to the original
program setting for the next arming cycle.
SILENT ARMING / DISARMING: Press
+ button together to arm or disarm your security
system. No chirp sound will be heard; arm / disarm confirmation will be through the vehicle’s
parking lights only.
B. PASSIVE ARMING
This system is equipped with passive arming feature, which allows the system to arm itself in 30
seconds after the last door is closed; operation is as follows:
1. Turn ignition to OFF position and exit the vehicle
2. After all entrances are closed, the system will start counting and LED flashes for 30 sec., if you
re-open any door / trunk / hood the system will stop counting and the LED will stop flashing. It
will start re-counting again once all vehicles’ entrances are closed.
3. After 30 seconds has elapsed, the security system will automatically “ARM”. The siren will chirp
once and the parking lights will flash once.
REMOTE PASSIVE:
You can use the remote transmitter to both enter and to exit the passive mode, eliminating the
need to hand your transmitter to parking attendants or garage mechanics.
a). Press and release button for 2 seconds. The system will enter the passive mode. One
long chirp confirms entry to the passive mode.
b). Press and release
button for 2 seconds. The system will exit the passive mode. Two long
chirps confirm exit of the passive mode.
PASSIVE DOOR LOCKING
The vehicle doors will automatically lock after passive arming cycle has been completed.
C. ACTIVE DISARMING – UNLOCK & DISARM:
Press button on the transmitter, the siren will chirp twice and parking lights will flash twice to
indicate the security system is now disarmed. The vehicle doors will unlock when interfaced with
the security system.
TAMPER DISARMING: If the alarm has been triggered, upon disarming the system, the siren will
chirp 4 times and the parking lights will flash 3 or 4 times.
AUTO RE-ARM: The security system will auto re-arm itself within 30 seconds after disarming by
remote transmitter. Auto re-arm will be canceled if any protected door has been opened before the
30 seconds timer has elapsed.
PANIC FUNCTION:
The transmitter can be used as a remote panic switch to manually trigger the alarm in case of
emergency.
1. Under the arming mode press and hold button for over 3 seconds. The siren will sound and
the parking lights will flash.
To stop the panic mode press or button and the panic mode will turn off immediately.
If the button is not pressed, the alarm will automatically stop in 30 seconds.
D. TRIGGER THE SYSTEM
When the alarm system is armed, your vehicle is protected as follows:
1.
Light impact will trigger the warn-away signal. A long chirp from siren.
2. Heavy impact / Door open / Hood open / Trunk open / Turning on the ignition switch; all will
trigger the programmed sequence.
For above (2) The siren and parking light will turn on, alerting of an intrusion for 30 seconds. Then
it will stop and automatic reset / re-arm. If any one of the sensors or detectors is still active, the
alarm system will sound a maximum of 3 times of 30 seconds cycles. The starter disable relay (if
installed) prevents the vehicle’s starter from cranking.
E. ANTI CAR - JACKING
Warning: If you don't need anti car-jacking function in this alarm system, be sure to set anti car-
jacking feature “DISABLE”. This system is default setting all anti car-jacking “ DISABLE ”.
1). With the Ignition “on”, press and hold
+ button on the transmitter for over 2 seconds.
The parking light will turn on for 2 seconds to indicate activation of anti car – jacking mode.
2). TRIGGER THE ANTI CAR - JACKING MODE:
3-timer circuits will function as follows:
First timer:
1. 50 seconds after the system has been triggered, the siren will start chirping for 15 seconds.
2. During this 15 seconds period of chirping, you will be alerted to press and hold + button on
the transmitter for over 2 seconds to turn off the anti car-jacking feature; parking lights will flash
twice and siren will chirp twice confirming success in turning off the anti car-jacking mode.
3. If not, it will enter the second timer of anti car- jacking feature
Second timer:
65 seconds after the system has been triggered. The siren start sounding and the parking lights
will start flashing.
Third timer:
90 seconds after the system has been triggered
a. The siren will continue sounding and the parking lights flashing, and
b. The starter disable will activate to prevent vehicle from starting.
c. It will remain active until the vehicle’s battery power exhausted.
F. DISARMING WITHOUT A TRANSMITTER
The Override function may be used if the remote transmitter is lost or inoperative.
1. Turn ignition switch to 'ON’ position and the LED will start flashing, indicating the system has
entered the password override mode.
Once the LED has flashed the same number of times as your password number, then turn the ignition
key “OFF”; the alarm will stop sounding and enter the disarm mode. You can now start and operate
the vehicle normally.
Example: If your programmed Password Code is “ 5 ” you would;
1. Turn the ignition switch to the 'ON’ position and the LED will start flashing, indicating the system
has entered the password override mode.
2. Wait until the LED flashes for the 5th time, then the turn ignition key OFF immediately.
The alarm will stop sounding and enter the disarm mode. You can now start and operate the
vehicle normally.
G. IGNITION CONTROL DOOR LOCK.
If the vehicles’ door locks have been interfaced to the security system, the system will
automatically lock the vehicle's door when the ignition “ON” and unlock vehicle’s door when
ignition “OFF”.
H. CAR LOCATOR
Under the armed mode press
button to activate car locator,
siren will chirp 6 times and parking lights flash 12 times for
you to easily locate your car.
LED INDICATORS:
LED Function
Off Disarmed
Slow flash Armed
Fast flash Passive arming
CHIRP INDICATORS:
Chirp Function
1 chirps Arm
2 chirps Disarm
3 chirps Door ajar warming
4 chirps Disarm / shock sensor trigger
6 chirps Car locator
PARKING LIGHTS:
ALARM OPERATION CONDITIONS:
Parking light Function
1 flash Arm
2 flashes Disarm
3 flashes Disarm / trigger on ignition or door
pin switch
4 flashes Disarm / trigger on shock sensor
12 flashes Car locator
Siren Parking
Light LED Door Starter
“CUT”
Arming 1 or 3
Chips 1 Flash Slow
Flash
Locking On
Disarming 2 or 4
Chirps
2 or 3 or
4
Flashes Off or
Fast
Flash Unlocking Off
Trigger Alarming Flashes Slow
Flash
On
Panic Alarming Flashes Slow
Flash
On