Comprehensive CVG-21RCA - Manual (Page 8)

6
5.2 Connecting the CVG-21RCA as a 1x2 Composite Video/Audio Switcher
To use your CVG-21RCA as a 1x2 composite video/audio switcher, connect
the CVG-21RCA as the example in Figure 3 illustrates:
1. Connect a composite source (for example, a VCR “Composite Source”) to
the three OUTPUT
1
channels, as follows:
• Connect the composite video channel to RCA connector A
• Connect the left stereo channel to RCA connector B
• Connect the right stereo channel to RCA connector C
2. Connect the three INPUT
2
1 channels to a composite video acceptor (for
example, a monitor “Composite Acceptor 1”), as follows:
• Connect the composite video channel to RCA connector A
• Connect the left stereo channel to RCA connector B
• Connect the right stereo channel to RCA connector C
3. Connect the three INPUT
2
2 channels to a composite video acceptor (for
example, a monitor “Composite Acceptor 2”), as follows:
• Connect the composite video channel to RCA connector A
• Connect the left stereo channel to RCA connector B
• Connect the right stereo channel to RCA connector C
4. Push in the front panel INPUT SELECTOR switch to route the source to
Acceptor 2, or release it to route the source to Acceptor 1.
Figure 3: Connecting the CVG-21RCA as a 1x2 Composite Video/Audio Switcher
1 Serve as the INPUT channels when operating in the opposite direction
2 Serve as the OUTPUT connectors when operating in the opposite direction