Avanti VM302W - Manual (Page 9)

9
INSTALLATION INSTRUCTIONS
 Before Using Your Appliance
 Remove the exterior and interior packing.
 Check to be sure you have all of the following parts:
1 Instruction Manual 1 Plastic Spatula
1 Thermostat Key 1 Ice Cube tray
 Before connecting the appliance to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
 Clean the interior surface with lukewarm water using a soft cloth.
 Installation of Your Freezer
 Place your freezer on a floor that is strong enough to support the freezer when it is fully loaded.
To level your freezer, adjust the legs at the front of the freezer.
 Allow 5 inches of space between the back and sides of the freezer, which allows the proper air
circulation to cool the compressor.
 Locate the freezer away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the freezer not to perform
properly.
 Avoid locating the freezer in moist areas. Too much moisture in the air will cause frost to form
quickly on the evaporator requiring more frequent defrosting of the freezer.

Plug the freezer into an exclusive properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and or grounding should be directed toward a certified electrician or an
authorized Avanti Products service center.
OPERATING YOUR FREEZER
 Temperature Control
 The first time you turn the unit on using the thermostat key provided set the temperature control to
the maximum setting or the “4” position. (See page 6 for thermostat location).
 The range of the temperature control is from position" OFF" the warmest to “4 the coldest. After 24 to
48 hours, using the thermostat key provided adjust the temperature control to the setting that best
suites your needs. The setting of “3” should be correct for home or office freezer use.
NOTE:
 If the unit is unplugged, power lost, or turned off; you must wait 3 to 5 minutes before restarting
the unit. If you attempt to restart before this time delay, the freezer will not start.
 Defrosting Your Freezer
 When? For the most efficient operation and minimum energy consumption, defrost the freezer
compartment when the frost on the freezer walls is excessive or ¼ inch thick.
 How? To start defrosting, unplug the freezer, remove the food and baskets. After the frost or ice has
melted, discard the melted water and dry up the interior of refrigerator. Then the freezer can be
restarted by a turning its thermostat to the desired setting.
CAUTION
Do not use boiling water because it may damage the plastic parts. In addition, never use
a sharp or metallic instrument to remove frost as it may damage the cooling coils and
will void the warranty. We recommend using a plastic scraper.
 Use a sponge or towel to pick up the melting ice off the freezer floor.
 Remove the frozen food from the freezer and place it in a cooler to protect the food.