IQinVision 7 Series - Manual (Page 3)

3
2 Audio/Trigger Pin Out
3 Getting Started
1. Plug the IQeye camera into the network.
2. Power the camera using either Power-over-Ethernet or direct power.
Power-over-Ethernet: Input from an IEEE802.3af Power-over-Ethernet (PoE)
power injector or switch as show in Figure 1.
Figure 1
Direct Power: Connect either a 12-24VDC or 24VAC power source to the camera.
Wire polarity is not important, therefore + or - connections can be connected to
either terminal as shown in Figure 2.
Figure 2