Caution – Cashco 1078 - Tank Blanketing User Manual
Page 6

6
IOM-1078
TABLE 1
Identifi cation Grooves for reduced fl ow plugs for verifi cation when the valve is fully assembled.
1” and 2” Vacu-Gards
Flow plugs are steel stamped with their size on the fl at tip as follows:
1” Valve
2” Valve
100
100
75
80
50
60
25
40
10
20
This number represents the percentage of maximum fl ow that is allowed through the valve. The number is marked
on the fl at tip of the plug and is not visible when the valve is assembled. Therefore all fl ow plugs (except the 100%
plug) are marked with circumferential grooves that are visible from the inlet port of a fully assembled valve. The
identifying grooves are as follows:
FLOW PLUG SIZE
No. of Grooves
1” Valves
2” Valves
None
100% (barely visible)
100% (not visible)
1
75%
80%
2
50%
60%
3
25%
40%
4
10%
20%
NEW REPLACEMENT UNIT:
Contact your local Cashco, Inc., Sales Rep re sen ta-
tive with the Serial Number, Product code and the
pressure/vacuum settings. With this information they
can provide a quotation for a new unit including a
complete description, price and availability.
VII. ORDERING
INFORMATION:
NEW REPLACEMENT UNIT vs PARTS "KIT" FOR FIELD REPAIR
To obtain a quotation or place an order, please retrieve the Serial Number and Product Code that was
stamped on the metal name plate and attached to the unit. This information can also be found on the Bill of
Material (parts list) that was provided when unit was originally shipped.) (Serial Number typically 6 digits).
PARTS "KIT" for FIELD REPAIR:
Contact your local Cashco, Inc., Sales Rep re-
sen ta tive with the Serial Number and Product
code. Identify the parts and the quantity
required to repair the unit from the Bill of Ma-
terials sheet that was provided when unit was
originally shipped.
NOTE: Those part numbers that have a quantity
indicated under "Spare Parts" in column "A”
refl ect minimum parts required for inspection
and rebuild, - "Soft Goods Kit". Those in col-
umn “B” include minimum trim replacement
parts needed plus those "Soft Goods" parts
from column "A".
If the "BOM" is not available, refer to the cross-
sectional drawings included in this manual for
part identifi cation and selection.
Local Sales Representative will provide quo-
tation for appropriate Kit Number, Price and
Availability.
CAUTION
Do not attempt to alter the original construction of any
unit without assistance and approval from the factory.
All purposed changes will require a new name plate with
appropriate ratings and new product code to accomo-
date the recommended part(s) changes.
SECTION VII