Hydrotech 5600 SE Valve Chem Free Iron Filter Operation Manual - Manual (Page 13)

11
Automatic Bypass
Your filter is factory set to backwash at 11:00 p.m. during a period of little or no water use. The backwash cycle lasts
approximately 15 minutes, after which filtered water service is restored. While backwashing is taking place, raw water
automatically bypasses the filter if required. If possible, avoid using water during backwashing to prevent iron-laden
water from entering your household plumbing system.
(Installation Tip: The 5600SE Filter should not be allowed to regenerate at the same time as any other water
treatment units. If adjustment is required, consult programming chart to adjust default regeneration time.)
New Sounds
You will notice new sounds such as the hum of the timer as your filter operates. During backwashing it will not be
uncommon to hear water running to the drain.
Manual Bypass
In case of an emergency you can isolate your water filter from the water
supply using the bypass valve located at the back of the control.
In normal operation the bypass is open with the ON/OFF knobs in line with
the INLET and OUTLET pipes. To isolate the filter, simply rotate the knobs
clockwise (as indicated by the word BYPASS and arrow) until they lock.
You can use your water related fixtures and appliances as the water supply
is bypassing the filter. However, the water you use will be untreated.
To resume filtered water service, open the bypass valve by rotating the
knobs counter-clockwise.
Manual Regeneration Cycle
If you run out of filtered water because of inadequate regeneration frequency, inadequate reserve capacity, power failure
or unusually high water usage, you can initiate a manual regeneration simply by pressing the extra cycle button. The
filter will now automatically complete a regeneration cycle and return to service. If possible, avoid water use during the
regeneration cycle.
Once you have set your filter and you experience frequent loss of water pressure, you may have to increase the
frequency of regeneration by resetting the gallons between regeneration.
Maintenance Instructions
Maintenance of your new water filter requires very little time or effort but it is essential. Regular maintenance will ensure
many years of efficient and trouble-free operation.
Care of All Water Filters
To retain the attractive appearance of your new water filter, clean occasionally with a mild soap solution. DO NOT use
abrasive cleaners, ammonia or solvents. Never subject your filter to freezing.
OUTLET
INLET