Hydrotech SL10-1 POU Scaleless - Manual (Page 2)

2
NOTICE TO INSTALLER:
• Do not discard this manual after installation. This manual contains important operation, maintenance and precautionary
information. Please present this manual to user/operator/owner after installation.
• It is strongly encouraged that you read this manual before installing system to ensure the best possible installation.
• Installation must conform to all local and state plumbing codes and regulations.
• Connect system to cold water supply only. Water temp. Can not exceed 100°F/28°C.
• System must be installed in a vertical and upright position.
• Scaleless systems must not be used in conjunction with polyphosphate or any other scale inhibitor.
• Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after
the system.
• Notice to user/operator/owner: Please retain this manual for future reference for parts, maintenance or trouble-shooting.
• It is recommended that all personnel responsible for operation and maintenance of this product read the precautions,
operation and maintenance sections of this manual.
Introduction
Your new Scaleless Filtration System will filter and condition the tap water providing optimum water characteristics for their
specified applications. The result is reduced equipment maintenance requirements, longer equipment life and improved
quality & consistency of your products. Proper system installation and routine filter changes will ensure years of trouble-free
operation and performance.
The Scaleless System is built with the finest and most advanced materials and each system is quality inspected and pressure
tested prior to shipment. With proper installation and routine maintenance, you will have years of trouble-free operation.
Please refer to this manual when performing routine filter changes. The instructions make periodic maintenance quick and
easy, and ensure you will receive maximum benefit from your system.
Item # Model #
Maximum Flow
Rate (GPM)
Capacity
gallons
Frequency of
Replacement
Connections
I/O
Dimensions (H x
W x D) Weight (lbs)
Replacement
Filter Item #
26171 SL10-1 1 525,000 1 Year 1/2” 15” X 5.5” X 5.5” 10 26270
26172 SL20-2 2 1,050,000 1 Year 1/2” 25” X 5.5” X 5.5” 16 26271
26173 SL20BB-5 5 2,100,000 1 Year 3/4” 28’ X 7.5” X 9” 18 26272
Technical Specification
Max. Water Temperature 30 Deg C (100 Deg F)
Min. Water Temperature 2 Deg C (35 Deg F)
Max. Water Pressure 125 psi (861 kPa)
Maximum Recommended
Flow Rate
1 GPM (3.78 LPM)
Service Life One Year
Capacity (Grains)
These Cartridges do not have grain removal capacity,
however, other contiminants present in the water will
gradually degrade the effectiveness of this cartridge. It is
recommended to change the cartridge altleast once
a year
Do not use where water is microbiologically unsafe without adequately treating the water before or after the system
At the stated service flow rates, the pressure drop through these devices will not exceed 15 psig.
!