To de-register all handsets, To deregister all handsets, Expansion handset – AT&T CL81219 User Manual
Page 46: Deregistering a handset

41
Appendix C
Expansion handset
Deregistering a handset
You can deregister handsets. You may need to deregister your handsets if:
You have twelve registered handsets and need to replace a handset.
-OR-
You wish to change the designated handset number of your registered
handsets.
You must first deregister ALL the handsets, and then re-register each handset
you wish to use.
Please read carefully through all the instructions on this page before
beginning the deregistration process.
To deregister all handsets
1. Press and hold
HANDSET LOCATOR on the telephone base for about 10
seconds (until the
IN USE light starts to flash), then release the HANDSET
LOCATOR button.
2. Immediately press and release
HANDSET LOCATOR again. You must
press
HANDSET LOCATOR while the IN USE light is still flashing. (The
light flashes for about seven seconds. If the light stops flashing, pick up the
handset and place it back into the telephone base, then start again with step
one above.)
3. The handset(s) shows
CONNECTING... and it takes about 10 seconds to
complete the deregistration process. ALL handsets shows
NOT REGISTERED
when deregistration is successful.
4. To re-register the handset(s) to the telephone base, follow the registration
instructions on page 40.
NOTES:
1. If the deregistration process is not successful, you might need to reset the system and try again.
To reset: pick up the handset and press the
PHONE/FLASH button, then press the
OFF/CLEAR button and place the handset back into the telephone base. You can also reset by
unplugging the power from the telephone base and plugging it back in.
2. You cannot deregister the handset(s) if any other system handset is in use.
3. Even if the battery is depleted, you can still deregister the handset by following the steps above.
After the handset is charged for at least 30 minutes, the screen shows
NOT REGISTERED.