Avanti ORC2519SS User Manual

Page 8

INSTALLATION INSTRUCTIONS

 BEFORE USING YOUR BEVERAGE COOLER

 Remove the exterior and interior packing.
 Check to be sure you have all of the following parts:

1 Instruction

Manual

2 Beverage

Baskets

2 Keys
2

Casters with Brakes

2 Casters

without

Brakes

1 Hanging

Basket

Handle Assembly with Screws (6)

1 Protective

Cover

Bottle opener with screws (2)

1 Allen

Wrench

 Before connecting this appliance to the power source, let it stand upright for approximately 2

hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.

 Clean the interior surface with lukewarm water using a soft cloth.

 INSTALLATION OF YOUR BEVERAGE COOLER

 This appliance is designed to be for free standing installation.

Place your Beverage Cooler on a floor that is strong enough to support it when it is fully
loaded.

 Your Beverage Cooler is designed to either be moveable using the casters (included).

 Install the casters (included) as shown in this manual on page 9.

 Locate the Beverage Cooler away from sources of heat (stove, heater, radiator, etc.). Direct

sunlight may affect the acrylic coating and heat sources may increase electrical consumption.
Extreme cold ambient temperatures may also cause the unit not to perform properly.

 Avoid locating the unit in moist areas.
 Plug the Beverage Cooler into an exclusive, properly installed-grounded wall outlet. Do not

under any circumstances cut or remove the third (ground) prong from the power cord. Any
questions concerning power and/or grounding should be directed toward a certified electrician
or an authorized Avanti Products service center.

 Collapsible

Table:

1) To lift it up, grab side and push upwards.
2) To bring down table, lift top slightly and push latch up as shown on sketch until it releases.