Grace Digital GDI-AQBLT300(B) Mini Bullet - Manual (Page 6)

P.5
button is pressed, frequency tuning starts automatically and it stops when a signal is
detected. The POWER LED will illuminate steadily once connected.
 Keep a distance of the speaker up to 7 meters apart from transmitter, and
then press “SCAN” AUTO TUNE button for best tuning reception.
 You should now be able to place the speakers freely from room to room without
disruption. Should you experience a “frequency jam”, adjust the channels by
switch from one channel to the other channel on the transmitter, and then press the
“SCAN” AUTO TUNE button on the speaker again.
NOTE: The signal from the transmitter will decrease in strength over
increased distances and as barriers and interference increase.
6. Adjust the volume to the desired listening level. Volume can be adjusted up by
pressing “+” button or down by pressing the button “-“ to the desired listening level
NOTE: IF disruption should occur (signal breaks up), press the
“SCAN”
auto-tuning button on the speaker to maximize best reception.
IF you hear interference from other devices, switch between the channels on the
transmitter and press the
“SCAN” auto-tuning button for best reception.
NOTE: batteries should be removed from the transmitter & speakers for extended storage
periods. Move speakers indoors when weather conditions are extreme.
6. Outdoor, Water Use & Weather Conditions
 Mini-Bullets II speaker is designed to be used in conservative outdoor conditions
 The speaker should not be operated in extreme temperature
 The transmitter and adapters must NOT be used in any type of water body or in a
moist or wet environment.
WARNING:
The power adaptor included with your unit is intended for indoor
environments and use. Do NOT use the power adapter in moist or wet
environments. Where there is a chance of rain, you may operate the
speaker with battery power.
TROUBLE SHOOTING