The remote control unit can be used to provide manual switching between
systems.
Note: The remote control cannot be used in conjunction with the Adder TS4
when a Synchrony auto switching link is being used because they both use the
same switching socket.

To connect the remote control

1 On the underside of the Adder TS4 unit, ensure that switch 5 is switched

OFF. Note: The switch settings are consulted by the unit only during its
power up phase, i.e. when power is first supplied by a keyboard socket
of a powered system. Therefore, change the setting while the unit is
disconnected or use switch 8 to force a reset, whereupon the other switches
will be consulted.

2 Locate the remote control unit and the remote control cable. Attach the

smaller of the two cable connectors to the socket at the rear of the remote
control.

3 At the other end of the cable, attach the larger connector to the socket on

the end of the Adder TS4 unit.

Optional power supply connections

Note: The Adder TS4 can obtain its power from the keyboard connections of any
of the four connected systems. Thus, an external power supply is not required
unless the connection cables used exceed 2 metres.
Important: Please read and adhere to the electrical safety information given
within the

Safety.information

section of this guide. In particular, do not use an

unearthed power socket or extension cable.

To connect the optional power supply

1 Attach the output connector of the power supply (country specific power

supplies are available) to the socket on the far left of the rear panel of the
Adder TS4.

2 When all other connections have been made, connect the main body of the

power supply to a nearby earthed mains socket.