Asus P/I-XP55TVP4 - Manual (Page 30)

24 ASUS P/I-XP55TVP4 User’s Manual
III. INSTALLATION
16. IrDA-compliant infrared module connector (IR)
This connector supports the optional wireless transmitting and receiving infra-
red module. This module mounts to a small opening on system cases that sup-
port this feature. You must also configure the setting through "UART2 Use
Infrared" in Chipset Features Setup to select whether UART2 is directed for
use with COM2 or IrDA. Use the five pins as shown on the Back View and
connect a ribbon cable from the module to the motherboard according to the pin
definitions.
Front View
+5V IRTX
IRRX
NC GND
Back View
IRRX
+5V
IRTX
NC
GND
Infrared Module Connector
17. ATX Power Supply Connector (20-pin block)
This connector connects to a ATX power supply. The plug from the power
supply will only insert in one orientation because of the different hole sizes.
Find the proper orientation and push down firmly making sure that the pins are
aligned.
IMPORTANT: Make sure that the ATX power supply can take at least
10mAmp load on the 5Volt standby lead (5VSB). You may experience diffi-
culty in powering on your system without this.
3.3V -12.0V GND PS-ON GND GND GND -5.0V 5.0V 5.0V
PW
-0K
12.0V
3.3V 3.3V GND 5.0V GND 5.0V GND
5VSB
ATX Power Connector
(Connectors)
III. INST
ALLA
TION