AVE TwistPlex UTP 4X1500 - Manual (Page 2)

Top Cover
Base Cover
Step 4 Top and back cover are separated as shown below. Step 1 Remove the two countersunk screws from the rear of
the metal case using a cross head screwdriver.
Step 2 Hold onto the main case assembly with one hand
supporting the top cover.
Step 5 Use the back cover as a template to mark the holes at
the location required to mount the hubs.
Step 6 Prefer to drill a small hole on the location mark for
easy mounting of the screws.
Step 3 Press slightly on the back cover using the left hand
thumb and slide the back cover using the right hand.