AmpliVox SW212 - Manual (Page 3)

3
PACKAGE CONTENTS SPECIFICATIONS
Rated Power Output: 30 W Dynamic
AC Power: 110 V
Wireless Range: 61 to 128 ft.
VHF Wireless Frequency: 165 - 265 MHz
Speaker: 6 1/2"
Frequency Response: 100Hz to 15KHz
Sensitivity: 60dB
Weight: 7.5 lbs.
Dimensions (HWD ): 11.25 in. H x 9 in. W x 6.5 in. D
TIPS
 Take care in selecting volume level, and speaker placement so that acoustic feedback (howling and screeching) will
be avoided.
 Also, microphones that are farther from the sound source, such as lapel, require more acoustic gain and thus are
also more prone to feedback than close-source microphones such as handheld or headset microphones that are
used close to the mouth.
MICROPHONES
GAIN CONTROL
MICROPHONE INPUT JACK
POWER SWITCH
OFF—STANDBY—ON
BATTERIES
 Handheld Wireless Microphone - Screw off
the lower bottom section of microphone and
insert a 9V rechargeable battery.
 Wireless Bodypack - Slide open the case
and insert a 9V rechargeable battery.
 These batteries can be recharged inside of
the SW212 (see Back Features).
 Battery life is about 8 hours.
Alakline batteries can be used but cannot be
recharged.
MICROPHONE OPERATION
Turn on SW212, Set Wireless Microphone Volume Control
at half way.
 Handheld Wireless Microphone - Slide switch to the
"ON position. Talk into microphone and adjust volume.
 Wireless Bodypack - Connect either the Lapel or
Headset Microphone into the input jack on the Wire-
less Bodypack. Set Gain Control at half way. Slide the
Power Switch to ON. LED will light. Speak into micro-
phone and adjust the Gain control to desired loud-
ness. NOTE: The center position of the Power Switch
is to be used when you want to temporarily quite mi-
crophone.
 SW212 Amplified Speaker
 Wireless Handheld Microphone
 Wireless Transmitter
 Lapel Microphone
 Headset Microphone
 Power Cord
 1/4" - 1/4" Line Cord
 Protective Cover/Carry Case